Easy Home R09 Manual De Instrucciones página 11

3. INSTALL THE ACCORDION PANELS
NOTE: The top rail and sliding panels at each side are
offset to provide the proper pitch to the rear of 5/16 in.
(7.9mm). This is necessary for proper condensed water
drainage. If you are not using the accordion panels for
any reason, this pitch to the rear must be maintained.
A. Place the unit on the floor, a bench or a
table. Hold the accordion panel in one hand
and gently pull the center to extend the panel
as needed (Fig. 1).
B. Slide the free end of the "Ⅰ" section of the panel
directly into the cabinet as shown in Fig. 2. Slide
the panel down. Be sure to leave enough space
to slip the top and bottom of the frame into the
rails on the cabinet.
C. Once the panel has been installed on the side of
the cabinet, make sure it sits securely inside the
frame channel by making slight adjustments as
needed. Slide the top and bottom ends of the
accordion frame into the top and bottom rails
of the cabinet (Fig. 3).
D. Slide the panel all the way in and repeat
on the other side (Fig. 4).
NOTE: If a storm window is blocking
the air conditioner, see Fig. 11.
Fig.1
"Ⅰ" section
Fig. 3
Top Rail
Bottom Rail
Fig. 4
Top rail
Top left
Bottom rail
Bottom rail
Installation
Fig. 2
Top right
11