Operation - Easy Home R09 Manual De Instrucciones

Operation

WARNING
important safety instructions before operating this appliance.
CAUTION
changing from Cool to Fan and back to Cool. This prevents the compressor from over-
heating and the possibility of the circuit breaker tripping.
To begin operating the air conditioner, follow
these steps:
1. Set the thermostat to the coolest number.
2. Set the selector control to the highest
Cool setting.
3. Adjust the louvers for comfortable
airflow by using the lever.
4. Once the room has cooled, adjust the
thermostat to the setting you find most
comfortable.
5. Make sure that the airflow inside and
outside are not obstructed. The lever
will allow you to direct the airflow toward the left or right throughout the room as needed.
Move the lever from side to side until the desired left/right direction is achieved.
Additional things you should know:
Now that you are familiar with the operating procedure, here are a few more features that you
should know:
• The cooling circuit has an automatic 3-minute time delay start if the unit is turned off
and on too quickly. This prevents overheating of the compressor and possible circuit breaker
tripping. The fan will continue to run during this time.
- To reduce the risk of fire, electrical shock, or injury, read the
- Always wait 3 minutes when turning the unit off then on again, and when
AIR DIRECTIONAL LOUvERS
Lever
Operation
18