Remote Control Operation - Easy Home R09 Manual De Instrucciones

Remote control operation

1 ON/OFF button
Press ON/OFF button to turn unit on or off.
Note: The unit will automatically initiate the
Energy Saver mode under COOL, DRY
and AUTO modes.
2 MODE button
Each time you push the button, a mode is
selected in the following sequence: AUTO,
COOL, DRY and FAN.
AUTO COOL
3 ENERGY SAvER button
Press ENERGy SAvER button to initiate this function. This function is available on COOL,
DRY, AUTO modes. The fan will continue to run for 3 minutes after the compressor shuts off.
The fan then cycles on for 2 minutes, at 10-minute intervals, until the room temperature is
above the set temperature, at which time the compressor turns back on and cooling starts.
1
4 TEMP/TIME adjustment button
2
Push the button to increase the indoor temperature setting or to adjust the TIMER in a
clockwise direction. Push the
adjust the TIMER in a counter-clockwise direction. Push
seconds to alternate the temperature display between Farenheit and Celcius.
5 SLEEP button
Press SLEEp button to initiate the Sleep mode. In this mode the selected temperature will
increase or decrease by 2 °F (1 °C) over the next 30 minutes and by another 2 °F (1 °C) after
additional 30 minutes. The new temperature will be maintained for 6 hours before it returns
to the originally selected temperature. This ends the Sleep mode and the unit will continue to
3
operate as originally programmed. The Sleep mode program can be canceled at any time
1
during operation by pressing the SLEEp button again.
2
DRY FAN
C LO C K SET TEMP .
FAN SPEED
4
3
button to decrease the indoor temperature setting or to
C LO C K SET TEMP .
FAN SPEED
A U T O
C LO C K SET TEMP .
Remote control operation
O N
O FF
A U T O
On
C LO C K
SET TEMP .
Set
2 hours later
after setting
O N
O FF
button together for 3
FAN SPEED
O N
O FF
Off
Set
5 hours later
after setting
2
Start
Stop
10 hours later
after setting
E
F
Start
Stop
8 hours later
after setting
1
3
19