Easy Home R09 Manual De Instrucciones página 12

4. SECURE THE ACCORDION PANELS
A. With a firm grip on the air conditioner, carefully
place the unit into the window opening so the
bottom of the air conditioner frame is against the
window sill (Fig.5). Carefully close the window
behind the top rail of the unit.
NOTE: Check that the air conditioner is tilted back
about 5/8" to 3/4" (15.8 to 19mm) downward to the
outside. With proper installation, condensation should
not drain from the overflow drain hole during normal use.
If it is, increase the slope.
B. Extend the accordion panels out against the
window frame (Fig.6).
5. INSTALL THE SUPPORT BRACKET
A. Place the frame lock between the frame
extensions and the window sill as shown in
Fig.7. Drive 3/4" (19mm) or 1/2" (12.7mm)
locking screws through the frame lock and
into the sill.
B. Drive 3/4" (19mm) or 1/2" (12.7mm) locking
screws through the frame holes into the
window sash. (Fig.8).
NOTE: To prevent the window sill from splitting,
drill 1/8" (3mm) pilot holes before driving in the
screws.
Fig. 5
Measure from the cabinet edge
Inside
Fig. 6
Fig. 7
Fig. 8
Installation
Outside
Window
Sill
Window
Frame
12