Section 2 − Installation; Included With Your Unit; Selecting A Location - Miller Syncrowave 200 Manual Del Propietário Y Guía

2-1. Included with Your Unit

5
4
3

2-2. Selecting A Location

Movement
Location And Airflow
18 in. (460 mm)
18 in. (460 mm)
SECTION 2 − INSTALLATION
6
2
1
OR
1
8
2
3
7
4
5
9
6
7
8
9
.
For options and accessories see
back of book or contact your dis-
tributor.
1
1 Lifting Eye
2 Lifting Forks
Use lifting eye or lifting forks to
move unit.
If using lifting forks, extend forks
beyond opposite side of unit.
3 Line Disconnect Device
Locate unit near correct input pow-
er supply.
Position unit so air can circulate.
2
For information about sources of
high-frequency see Section 6.
For carts and caster kits see back
3
of book or contact your distributor.
!
Special installation may be
required where gasoline or
volatile liquids are present −
see NEC Article 511 or CEC
18 in.
Section 20.
(460 mm)
18 in. (460 mm)
12 ft (3.7 m) Work Cable
With Clamp And
Quick-Connect
WP1712SFDI 150 Amp
TIG Torch with 12 ft (3.7 m)
Cable And Quick-Connect
Electrode Holder and
Quick-Connect
Gas Hose
Gas Regulator
Cable/T orch Hanger
Foot Pedal Holder
8 ft (2.4 m) Primary Cord
Without Plug (208/230
Models Only)
RFCS-14 Foot Control with
20 ft (6 m) Cable
Some assembly is required.
804 464-B
OM-225 389 Page 5