Castor Wheel Replacement - Pegasolift PL13 Guía De Uso Y Mantenimiento

OTHER PERIODICAL CONTROLS :
Every 500 hours check if there are not damages or burns on the spring pushing the
brushes or on the rotor collector.
Each 1000 hours check if the bearings in double scheme with grease at high
temperature have not leakages; check the perfect fastening of the garnish, the good
fastening of electrical contacts and that the isolation against the mass is more than 2
Megohm.
1
1
REPLACEMENT OF THE FRONT ROLLERS
2
5
4
TRACTION WHEEL MAINTENANCE

CASTOR WHEEL REPLACEMENT

Also the posterior support wheel is subject to wear
itself. For replacement is necessary operate as
follows:
1) disconnect the start contact (reference page 17
"Tiller head" no. 5).
2) put the stacker on safe supports
3) remove the rear cover and the lower rear plate as
indicated at points 1, 2 and 3 of the paragraph
"replacement of the wheel ring" page 27.
4) remove the wheel (2) unscrewing the 4 hexagon
with head screws with self-locking nuts (1).
5) put at its place the new wheel paying attention to
the orientation of the fixing flange.
2
Also the front rollers are subject to wear. For
replacement is needed to:
1) raise the fork group at a height of about 1 meter
and disconnect the switch for disconnecting the
1
battery (reference page 17 "Instruments" no. 1)
3
2) put the stacker on safe supports.
3) extract the pin (1) and put free the carriage (3)
6
removing the pin (2).
4) makes free the roller (6) removing the external
ring (4) and the rotation pin (5).
5) replace the damaged roller, introduce the rotation
pin (5) fixing it with the elastic ring (4) and put
again the carriage at its place.
B 67
67