Cleaning Operation - Pegasolift PL13 Guía De Uso Y Mantenimiento

CONTROL OF THE FASTENING SYSTEM OF THE BATTERY:
It is important periodically to control in the battery space that:
1) the fastening screws of the battery (1) are not loose: in this case tighten them to the
bottom to avoid that batteries are blocked in their space
2) that in the areas next to the fastening screws are not traces of metal alterations, in
this case proceed as follows:
1. disconnect the socket at the interior of battery space (1)
2. dismantle the flange supporting the socket pushing on the two fastening screws
3. take out the battery removing the screws shown in figure (2)
4. carefully clean and eliminate the dirt from the corroded area;
5. paint again with anti-acid paint;
6. install again the battery and the flange supporting the socket fastening tight with the
screws
7. connect the back.
DANGER!
BATTERY IS SOLIDLY FIXED IN THE BATTERY SPACE: A
BAT T E RY LO O S E F I X E D C O U L D C AU S E S TAC K E R
INSTABILITY AND CONSEQUENTLY ITS OVERTURN
1) The cleaning operations should not be executed with easy inflammable liquids or with
tools from metals able to ruin the stacker body.
2) During the cleaning operations, all the electric parts should be covered in order to
avoid corrosion of contacts and short-circuits.
3) It is prohibited to execute the cleaning with water under pressure or with vapor
4) Before use the stacker, check if there are not water stains and that all the circuits are
dried up.
BATTERY MAINTENANCE
IT IS PARTICULARLY IMPORTANT THAT THE

CLEANING OPERATION

61
B 61
.