Fastener - Sauder Cannery Bridge 416082 Manual De Usuario

Step 7
Fasten the BRACES (T) to the BOTTOM (E2). Use four BROWN 1-1/2" FLAT HEAD SCREWS (14S).
å
Fasten the BOTTOM (E2) to the LEFT END (B). Tighten two TWIST-LOCK® FASTENERS.
å
BROWN 1-1/2" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/services
14S
T
T
E2
J
B
S u r
H I D
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the
adjoining part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoining part while locking
the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight
as possible.
Dowel end
f a c
e w
D E N i t h o
u t
C A
M S
416082
Caution
®

FASTENER

This hole should be
closer to this edge.
E2
Surface with
TWIST-LOCK®
FASTENERS
Page 11