1. Pilot air screw
1. Vis d'air de ralenti
1. Tornillo de aire piloto
EBU03021
Idle speed adjustment
NOTE:
A diagnostic tachometer must be used for this
procedure.
q
NOTE:
The throttle cables and carburetor synchroniza-
tion must be set properly before adjusting the
idle speed.
8-67
1. Adjust the pilot air screws.
8Turn in both pilot air screws until they
lightly seat.
8Turn out both pilot air screws to specifi-
cation. (Refer to the "Carburetor settings"
section.)
2. Remove the seat.
3. Start the engine and warm it up for a few
minutes at approximately 1,000 to 2,000
r/min.