Listening To Each Programme Source In Its; Registered Surround Menu; Last Sound Memory (Lsm); Changing The Line Output Level - Sony CDX-C880R Manual De Instrucciones

4
Rotate the dial to select the turn-over
f r e q u e n c y .
The turn-over frequencies change as
follows:
Bass:
198 Hz n 250 Hz n 314 Hz* n 396 Hz
Treble:
2.0 kHz n 3.1 kHz* n 4.0 kHz n 5.0 kHz
Factory-set frequency
*
5
Press (SOUND) for two seconds.
The display returns to the normal playback
mode.
Listening to each
programme source in its

registered surround menu

— Last Sound Memory (LSM)

Each time you return to the same source, you
can hear the same surround effect registerd for
that source, even after changing the
programme source or turning the unit off and
then on again.
Changing the line output
level
You can change the line output level if you
hear distortion or other noise.
1
Press (SHIFT) , then press
until "L.out" appears.
2
Press (5) ( n) to select the desired
setting (–10 dB or –16 dB).
3
Press (SHIFT) .
(3) (SET UP)
Additional
Information

Precautions

• If your car was parked in direct sunlight
resulting in a considerable rise in
temperature inside the car, allow the unit to
cool off before operating it.
• If no power is being supplied to the unit,
check the connections first. If everything is in
order, check the fuse.
• If no sound comes from the speakers of
two-speaker systems, set the fader control to
the centre position.
•If your car is equipped with a power aerial, it
will extend automatically while the unit is
operating.
If you have any questions or problems
concerning your unit that are not covered in
this manual, please consult your nearest Sony
dealer.
Notes on handling CDs
A dirty or defective disc may cause sound
dropouts while playing. To enjoy optimum
sound, handle the disc as follows.
Handle the disc by its edge. To keep the disc
clean, do not touch the surface.
Do not stick paper or tape on the labelled
surface.
continue to next page n
EN
39