Creating a programme
— CD Programme Memory
You can play the tracks in the order you want
by making your own programme. You can
make two programmes: Programme 1 and
Programme 2. You can select up to 12 tracks
for each programme. You can store the
programmes in memory.
1
Press (SHIFT), then press (4) (PLAY
MODE) for two seconds.
TRACK
PLAY
MODE
ENTER
"P 1" indicates Programme 1 is selected.
To select Programme 2, press (5) (n )
repeatedly until "P 2" appears.
2
Push the SEEK/AMS control up or down
to select the track you want.
3
Press (6) (ENTER) momentarily.
PLAY MODE
ENTER
µ
TRACK
PLAY
MODE
ENTER
4
To continue entering tracks, repeat steps
2 and 3.
5
When you finish selecting tracks, press
(4) (PLAY MODE) for two seconds.
6
Press (SHIFT).
Notes
• "*Wait*" appears in the display while the unit is
reading the data.
• "*Mem Full*" appears in the display when you
try to enter more than 12 tracks into a
programme.
Playing the stored programme
You can select:
•PGM 1 to play Programme 1.
•PGM 2 to play Programme 2.
•PGM 1+2 to play Programmes 1 and 2.
1
Press (SHIFT).
2
Press (4) (PLAY MODE) repeatedly until
"PGM" appears.
3
Press (5) (n ) repeatedly until the
desired programme appears.
Programme 1 playback
PGM1
PLAY MODE
µ
Programme 2 playback
PGM
2
PLAY MODE
µ
Programmes 1 and 2 playback
PGM1+2
PLAY MODE
µ
Normal playback
PLAY MODE
Programme Play starts.
4
Press (SHIFT).
To return to normal playback mode, select
"PGM off" in step 3 above.
Note
"Not ready" appears in the display if no track is
stored in the programme.
continue to next page n
EN
11