Installation Location; Start-Up - Adam Equipment EQUINOX EAB Manual De Usuario

2.2

INSTALLATION LOCATION

 Remove the balance and all its accessories, from the packaging and check for visible
damage to the balance.
 Do not install the balance in any room where there are any air currents, strong heat
shifts, and vibrations.
 Do not use the balance in explosive atmospheres.
 The ambient humidity to use the balance should be between 45% and 75%.
2.3

START-UP

For internal calibration models, manually remove the brass screw at
the bottom left-hand of the balance and in its place, insert the chrome
screw.
CAUTION!
EAB & EPB models
1) Level the balance by adjusting the legs on the front of the balance.
Adjustable feet
2) Insert the supplied power supply unit jack into the connector on the back of the balance.
© Adam Equipment 2018
Spirit level
6