Storage; Saw Chain And Chain Bar Combinarion - Scheppach CSH46 Manual Del Usuario

GB
Chain lubrication
Always make sure the automatic oiler system is
working properly. Keep the oil tank filled with Chain,
Bar and Sprocket Oil.
Adequate lubrication of the bar and chain during cut-
ting operations is essential to minimize friction with
the guide bar.
Never starve the bar and chain of lubricating oil. Run-
ning the saw dry or with too little oil will decrease cut-
ting efficiency, shorten saw chain life, cause rapid
dulling of chain, and lead to excessive wear of bar
from overheating. Too little oil is evidenced by smoke
or bar discoloration.
Instructions for sharpening a saw chain:
File diameter
Chainsaw type
91P ca. 4.0 mm
Important hint in case of sending the equipment
to a service station:
Due to security reasons please see to it that the
equipment is sent back free of oil and gas!
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Chain chain, guide rail, chain oil, engine
oil, nail clasp, chain catcher, spark plug, air filter, fuel
filter, chain oil filter
* Not necessarily included in the scope of delivery!
42 І 180
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Upper angle
Chucking rotation
angle inclination angle
30°
depth stop
Chain Sharpening
m NOTE!: For smooth and safe operation, it is im-
portant that the chain is always sharp. The chain
should be sharpened when:
• Wood shavings are dust-like.
• You have to expend extra power sawing.
• The saw cut is not straight.
• The vibration increases.
• Fuel consumption increases.
m NOTE
We recommend that a professional sharpen the
chain.
Upper tilt angle
lower angle
(55 °)
Chucking
side angle
0° 80°

10. Storage

m CAUTION
Never put a chain saw into storage for longer than 30
days without carrying out the following steps.
Follow the cleaning instructions and maintenance in-
structions before storing the device.
Storing a chain saw
Storing a chain saw for longer than 30 days requires
storage maintenance. Unless the storage instruc-
tions are followed, fuel remaining in the carburetor
will evaporate, leaving gum-like deposits. This could
lead to difficult starting and result in costly repairs.
Standard depth
0.64 mm
file