Technical Data; Storage; Transportation; Disposal And Recycling - Scheppach CSP41 Traducción De La Instrucción De Original

10.Technical data

Weight without bar and
chain
Weight with bar and chain
Cutting Length
Bar Length
Automatic chain oiling
Chain Oil
Chain oil tank capacity
Chain Division
Chain Thickness
Chain Brake
Chain Speed Max
Motor
Engine Capacity
Maximum Motor Capacity
Idle Speed
Maximum Speed with Cut-
ting Attachment
Fuel Tank Capacity
Fuel Type
Keep the noise emissions and vibrations to a
minimum.
• Only use appliances which are in perfect work-
ing order.
• Service and clean the appliance regularly.
• Adapt your working style to suit the appliance.
• Do not overload the appliance.
• Have the appliance serviced whenever necessary.
• Switch the appliance off when it is not in use.
• Wear protective gloves.
Sound Pressure Level L
pA
Uncertainty K
pA
Sound Power Level L
WA
Vibration Front Handle
Vibration Rear Handle
Uncertainty

11. Storage

m CAUTION
Never put a chain saw into storage for longer than 30
days without carrying out the following steps.
Storing a chain saw
Storing a chain saw for longer than 30 days requires
storage maintenance. Unless the storage instruc-
tions are followed, fuel remaining in the carburetor
will evaporate, leaving gum-like deposits. This could
lead to difficult starting and result in costly repairs.
48 І 164
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
4,5 kg
5,7 kg
375 mm
400 mm
yes
Specialist Chain Oil
210 cm³
3/8"
1,27 mm
yes
21 m/s
2 stroke, air-cooled
41 cm³
1,5 kW
3300±300 min
-1
11000 min
-1
0,26 l
Mix 40:1
99 dB(A)
3 dB
114 dB(A)
6,5 m/s²
6,0 m/s²
1,5 m/s²
• Remove the fuel tank cap slowly to release any
pressure in tank. Carefully drain the fuel tank.
• Start the engine and let it run until the unit stops
to remove fuel from carburetor.
• Allow the engine to cool (approx. 5 minutes).
• Remove the spark plug.
• Pour 1 teaspoon of clean 2-cycle oil into the com-
bustion chamber. Pull starter rope slowly several
times to coat internal components. Replace spark
plug.
m NOTICE
Store the unit in a dry place and away from possible
sources of ignition such as a furnace, gas hot water
heater, gas dryer, etc.
Puttig the saw back into operation
• Remove spark plug.
• Pull starter rope briskly to clear excess oil from
combustion chamber.
• Clean the spark plug and check that the electrode
gap is correct.
• Prepare unit for operation.
• Fill fuel tank with proper fuel / oil mixture.

12. Transportation

To transport the saw, empty the petrol tank. Re-
move coarse dirt from the saw with a bust or a
hand sweep

13. Disposal and recycling

The unit is supplied in packaging to prevent its be-
ing damaged in transit. This packaging is raw materi-
al and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic. De-
fective components must be disposed of as special
waste. Ask about recycling in the store or in the local
municipal administration!