Install/Empty Grass Catchment Basket; Operation; Level Gauge; Mulch Kit - Grizzly Tools ERM 1851 A Q-360 Traducción Del Manual De Instrucciones Original

GB
bar (5). Clamping levers to be
tightened and contacting the bar
such that they clamp at average
force.
Otherwise you may have to
tighten (turn clockwise) or loos-
en them (turn anticlockwise).
Clip on the cable hook:
Clip the three cable holders
( 4) onto the bar (5) and bow-
type handle (1) in order to se-
cure the device cable (21) and
Bowden cable (22).
Install/empty grass catchment
basket
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
D
Assemble grass catchment
basket (14):
Pull plastic loops (23) over basket
rods (24).
Fixing the Grass Collection
Box onto the Equipment::
The mulch kit and lateral ejection
canal must be removed prior to
using the collection bag. (See
).
1. Lift up shock protection (6).
2. Hook the grass collection
box (14) into the mounting pro-
vided for this (25) on the rear of
the equipment.
76
3. Release the impact protec-
tion (6). It holds the grass col-
lection box in position.
Dismantling/Empty out the
Grass Collection Box:
4. Lift the impact protection (6)
and remove the grass collection
box (14)
5. Empty catchment basket (see
chapter „Disposal / Environmen-
tal Protection") and re-install it.

Operation

Attention: Do not operate the ap-
pliance until the collision guard
and grass catcher are fully in-
stalled. Risk of injury!

Level gauge

The level gauge (
side of the grass catcher (
aerodynamic air guidance provided by the
flap also optimises the filling.
GO
Flap open: grass catcher empty
STOP Flap closed: grass catcher full

Mulch kit

Prior to using the mulch kit, the
lateral ejection canal has to be re-
moved. (see
,
Attaching mulch kit
1. Remove the collection box
(
2. Lift the impact protection (
3. Insert the mulch kit (8).
16) is located on the
14). The
)
14), if used.
6).