Install Handle - American Standard Portsmouth TU41550 Serie Instrucciones De Instalación

2 2
STANDARD WALL INSTALLATION
• Figure 1. Remove plaster guard from valve. Push CAP (1)
over VALVE CARTRIDGE (2) until seated against stop.
• Figure 2. Push ESCUTCHEON (3) onto CAP (1) and attach
to valve body with LONG SCREWS (4).
THIN WALL INSTALLATION
• Figure 1a. Push CAP (1) over VALVE CARTRIDGE (2) until
seated against stop.
• Figure 2a. Push ESCUTCHEON (3) onto CAP (1) and attach
to valve body with LONG SCREWS (4).
PLASTER
GUARD
Figure 1.
Figure 1a.
3
INSTALL, TUB SPOUT, SHOWER HEAD,
SHOWER ARM WITH FLANGE
Protect finish on SHOWER HEAD
CAUTION
and TUB SPOUT when installing.
Note: Apply sealant or Teflon Tape to shower arm.
• Remove PIPE PLUG and CAP (1, 2) from
shower pipe and tub filler pipe.
• Install SHOWER ESCUTCHEON (3) onto SHOWER ARM (4).
Apply sealant or Teflon tape to threads on both ends of
SHOWER ARM (4) and thread longer leg of SHOWER ARM (4)
into shower elbow. Thread SHOWER HEAD (5) onto SHOWER ARM (4).
• Install SLIP-ON TUB SPOUT (6). Tighten SET SCREW (7)
awith HEX WRENCH supplied
Important: Do not overtighten Set Screw.
4

INSTALL HANDLE

• Hold ADAPTER (1) onto VALVE STEM (2) and install
ADAPTER SCREW (3) through ADAPTER (1) into
VALVE STEM (2). Tighten ADAPTER SCREW (3) to
secure ADAPTER (1).
• Install HANDLE BASE (4) onto ADAPTER (1). Tighten
SET SCREW (5) with HEX WRENCH (6) supplied.
1
2
2
1
4
1
Figure 2.
1
Figure 2a.
1
OR TEFLON
1-3/4"
(44 mm)
- 2 -
3
4
3
4
3
4
APPLY
SEALANT
TAPE TO
THREADS
2
6
7
HEX WRENCH
H
3
4
C
f
O f
1
2
5
6
M965927 Rev. 1.1 (3/20)
H
C
O f f
H
C
f
O f
5