Power Supply - Soehnle Professional 7800 Instrucciones De Manejo


a



e
Installation instructions for 7800
c
1. Insert stand tube (a) in platform socket.
Make sure you do not pinch the cable.
2. Turn scale over and first insert the two fixing screws (b) and tighten.
Then insert levelling foot (c).
3. Fix cable to scale base using cable ties.

b
Getting started 7800, 7801, 7802, 7805
4. Insert batteries (4 x 1.5V AA) or connect the unit to a power supply.
Position the scale at its place of use. Make sure it is horizontal.
(On 7800 use levelling foot as aid).
5. On wheelchair scale 7802, block the rear wheels.
The scale is ready for operation.
Plug-in power supply unit
6. The socket (f) for connecting the supplied plug-in power supply unit
is located on the base of the display unit (d). Push display unit to the
rear and remove. Insert the cable and run it into the cable grip.
Then push display unit back onto display unit holder (e).
The power supply unit is not waterproof and therefore must not come
into contact with water.
Should the power supply unit become wet or show visible signs of damage,
do not operate the scale with the power supply unit. Please contact your
dealer or service partner.

Power supply

You can also operate the scale using Soehnle Professional rechargeable
batteries besides the plug-in power supply unit and zinc/carbon or alkali/
manganese batteries (4 x 1.5V AA).

Please note that the batteries are not charged when the power supply
unit is switched on. You require a separate battery recharging unit.
Recharging kit (optional)
You can obtain Soehnle Professional rechargeable batteries as part of
a separate kit, consisting of a recharging unit, Soehnle Professional
recharge able batteries and a safety sticker.
When inserted, Soehnle Professional rechargeable batteries have sufficient
charge for up to 200 hours of weighing (depending on the recharging
level of the batteries). During recharging (approx. 15 hrs), an indicator
lamp is lit on the recharging unit. Start a new loading cycle by removing
and then inserting the flat plug on the display unit. If you do not use the
rechargeable batteries for a long time, they will lose some of their capacity.
The batteries are fully charged after approx. 3 to 5 recharging cycles.
d
Replacement parts: Soehnle Professional rechargeable batteries,
recharging unit
When you insert rechargeable batteries into the unit, attach the supplied
sticker to the battery compartment.
f
1. The sticker reads as follows: Caution! Rechargeable Soehnle Professional
batteries in use, do not replace with other batteries.
Caution: if you use normal batteries with the battery recharging unit,
there is a danger of leakage and explosion. If you start using normal
batteries again, replace the battery recharging unit with the plug-in
power supply unit supplied with the scale.
2. The power supply unit is a battery recharging unit and can be recognised
by the LED on the housing.
ENGLISH
5