Setting Up The Scale; Scale Setup And Startup; Power Supply - Soehnle Professional 7730.65 Instrucciones De Uso

5.

SETTING UP THE SCALE

5.1

Scale setup and startup

The scale is fully assembled on delivery.
- Remove the packaging.
- Place the scale on a firm, level surface. Make sure that cables or other objects are not
pinched under the scale.
- Align the scale by undoing the foot screws. The air bubble in
the spirit level must be right in the centre of the circle.
For setup locations in Germany, this condition has been met when the
floor meets the tolerances specified by DIN 18202 Table 3 row 4.
For other countries, the respectively applicable standards may have to be referenced.
5.2

Power supply

Depending on the model, the scale is powered by a rechargeable battery, a mains unit or a
battery pack.
5.2.1 Connect power supply unit
1. Insert the power supply cable into the connecting socket on the rear of the scale.
2. Plug the mains unit into a power supply socket.
Make sure the power outlet remains easily accessible.
Only for rechargeable battery version:
3. Charge the rechargeable battery for 5 hours prior to initial startup. The blue pilot lamp in
the housing light up while the battery is charging. The LED expires as soon as the
battery is fully charged.
5.2.2 Insert batteries (battery version only)
1. Carefully turn over the scale so that the base of the
scale is accessible.
2. Take off the battery cover.
3. Place the batteries in the battery compartment.
The scale must only be operated by staff.
The scale is not intended for operation by the patient.
38
Battery compartment
www.soehnle-professional.com