Kit Assembly - Metra 95-9012 Instrucciones De Instalación

ISO DDIN radio provision
1. Slide the radio into the radio housing
from the rear, and then secure it to
the assembly using (8) Phillips 5mm
screws supplied. (Figure A)
2. Locate the factory wiring harness
and antenna connector in the
dash. Metra recommends using
the proper mating adapter from
Metra or AXXESS. Re-connect the
negative battery terminal and test
the radio for proper operation.
3. Test the radio for proper operation.
4. Snap the completed assembly into
the dash opening.
Attention: This installation kit is
an extremely tight fit and requires
force to be "snapped" into the dash
opening. Removal of the aftermarket
radio is even more difficult than
installation, so please be sure to fully
test the aftermarket radio and all
accessories prior to snapping it in.

Kit Assembly

(Figure A)
®
95-9012
3