Kobalt SGY-AIR88NB Manual Del Usuario página 12

ASSEMBLY INSTRUCTIONS
3. Set the air compressor to 60 PSI.
Attach air line coming from
compressor to the spray gun.
4. Open the air adjustment knob
(G) by turning it counterclockwise
approximately 1-1/2 turns. While
watching the gauge on the
compressor, pull the trigger on
the spay gun and make sure that
the gauge on the compressor is
reading 60 PSI. If necessary,
adjust the pressure coming out
of the compressor until the gauge
reads 60 PSI with the trigger
being pulled.
NOTE: If you use the air pressure
regulator adjust the air pressure so
the gauge on the regulator reads
60 PSI when the trigger is pulled.
5. Remove air line and Lid (I) by
turning it counterclockwise. Fill
the paint cup (H) about 3/4 of the
way. Screw the Lid (I) back
onto the paint cup (H) by turning
it clockwise.
NOTE: All accessories shown may
not be included.
3
4
G
5
Counterclockwise
H
12
Counterclockwise
I
Pour paint
G
Clockwise