Kobalt SGY-AIR88NB Manual Del Usuario página 14

OPERATING INSTRUCTIONS
3. Set pattern size for desired shape.
For full pattern, open spray pattern
adjustment knob (C) by turning
counterclockwise. For a round
pattern, turn spray pattern adjustment
knob (C) clockwise (See Figure 3).
4. With the spray gun 6 in. to 12 in. away
from workpiece, spray a short burst while
turning the fluid knob counterclockwise.
Observe the spray pattern on the
workpiece and adjust the fluid adjustment
knob (E) until desired pattern/atomization
is obtained. If the spray is too fine (caused
by too much air), reduce the air pressure
or open the fluid adjustment knob (E) to
spray more paint. If the spray is too coarse
(or is spitting blobs), reduce the amount of
paint with the fluid adjustment knob (E) or
thin the paint more (See Figure 4).
NOTE:
The fluid adjustment knob (E) can be
adjusted either clockwise or
counterclockwise to finely adjust the
pattern consistency. Before spraying on
workpiece, practice a few minutes on a
scrap workpiece to ensure that the pattern
size and consistency are set correctly.
5. Keep the gun at a right angle as shown
while spraying (See Figure 5).
NOTE: if paint cup is over filled and the gun
is not kept at a right angle during spraying,
there is a good chance that paint will leak
from the vent hole on top of the lid.
3
4
Pattern Consistency (Atomization)
5
14
C
Paint too fine
Correct
Paint too coarse
6-12 in.