Wolf Garten Lycos 40/400 M Manual De Instrucciones página 30

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 118
EN
Cleaning the grass collector (Fig.
Note
It is best to clean the grass collector directl
after mowing.
Raise the de ector ap
Remove the grass collector
Lower the de ector ap again
Empty the grass collector
Clean the fabric collection bag including the frame
with water or a hand brush.
In particular, clean the area beneath the ll level
indicator
.
Allow the fabric collection bag to dry before the
next use.
Transport and storage (Fig.
Risk of injuries due to the rotating mower
blade.
Before transport or storage, switch o
the lawnmower and wait until the mower
blade comes to a standstill.
Switch the lawnmower o and wait until the motor
blade comes to a standstill.
SAFETY ROUTINE
Open the cover
Turn the safety key anti-clockwise until it reaches
position "0"
, then remove it.
Press the power pack release
Remove the power pack
Close the cover
Secure the lawnmower su ciently to prevent its
unintentional slipping if you are transporting it in or
on a motor vehicle.
To make it easier to stow the lawnmower, you can
fold the handle together
To do this, release the two upper quick-release
levers together with the threaded pins
screw them out by approximately 5 mm. When
doing so hold the top part of the handle rmly, as
otherwise you could trap your hand or ngers.
Fold the top part of the handle down
Attention!
If you fold the handle bar forwards, the cable can
become damaged.
Release the two bottom quick release
levers
.
Fold both handles forwards and support them on
the front wheels of the lawnmower
This allows you to easily carry the lawnmower via
its handle or to move it to a secure location for
storage
(see arrow).
30
.
.
.
.
)
DANGER!
.
.
.
.
.
.
.
)
Storage during winter
Thoroughly clean your lawnmower after every
mowing season.
Arrange for a specialist workshop to check your
lawnmower in Autumn.
Store the lawnmower in a clean and dry room.
Protect the lawnmower against rust during long
storage periods in winter.
Never store the power pack inside the lawnmower!
Replacing the mower blade (Fig.
Risk of injuries.
Arrange for a specialist workshop to
replace the mower blade.
Only work on the mower if the motor is
stationary.
War suitable safety gloves.
Switch the lawnmower o and wait until the motor
blade comes to a standstill.
Open the cover
Turn the safety key anti-clockwise until it reaches
position "0"
Press the power pack release
Remove the power pack
Close the cover
Grinding the mower blade can result in an
imbalance. Arrange for a specialist workshop to
check for imbalance.
Note
se a torque wrench with a 1 mm soc et to
change the mower blade. Screw tightening
torque 8–11 Nm
and
Note
se onl the replacement blade appro ed
b the manufacturer for the corresponding
lawnmower. The appro ed blades are listed
in the enclosed E Declaration of onfor-
mit .
WARNING!
SAFETY ROUTINE
.
, then remove it.
.
.
Attention!
.
Servicing
)
.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Lycos 40/370m

Tabla de contenido