Philips 9000 Serie Manual Del Usuario página 22

22
English
2 Hold the shaver upside down above the holder.
Make sure the front of the shaver points
towards the SmartClean system holder (Fig. ).
3 Place the shaver in the holder (1), tilt the shaver
backwards (2) and press down the top cap to
connect the shaver ('click') (3) (Fig. ).
The battery symbol starts to flash, which
indicates that the shaver is charging.
4 Press the on/off button on the SmartClean
system to start the cleaning program (Fig. ).
During the rinsing phase, the rinsing symbol
flashes. When the rinsing phase is done (after
approx. 10 minutes), the rinsing symbol lights up
continuously (Fig. ).
After the rinsing phase, the drying phase starts
automatically. During this phase, the drying symbol
flashes. When the drying phase is done (after
approx. 4 hours), the drying symbol lights up
continuously (Fig. ).
When the cleaning program is done, the ready
symbol lights up continuously (Fig. ).
30 minutes after the cleaning program and
charging are done, the SmartClean system
switches off automatically.
The battery symbol lights up continuously to
indicate that the shaver is fully charged (Fig. ).
Charging takes approx. 1 hour.
Note: If you press the on/off button of the
SmartClean system during the cleaning program,
the program stops. In this case, the cleaning or
drying symbol goes out.
Note: If you disconnect the SmartClean system
from its power source, the cleaning program stops.