User Instructions - OKBABY Body Guard Manual Del Usuario

Chapter 7 Child's bicycle seat OKBABY BODY GUARD
7

User instructions

Figure 1:
Adjusting the footrests:
Release the foot strap from the out-
side of the regulating pin (B). To
adjust the height of the footrests (15),
turn the adjuster lever (16) upwards,
once you have found the right positi-
on, turn the adjuster lever downwards
to fix the footrests in place. Replace
the foot strap.
Figure 2:
Fastening and unfastening the child's
feet. To hold the child's feet in positi-
on, fix the foot strap on the inside of
the regulating pin (fig. 3 A) and then
fasten it to the outside (fig 3 B). To
release the foot strap follow the pro-
cedure in reverse.
Always make sure your child's feet
are well fastened to the footrests. The
safety belt is long for easy adjust-
ment.
DANGER! Always hook the foot
straps onto both sides of the faste-
ning pins to prevent them from
coming into contact with the wheel
spokes.
WARNING! Never pull the belt on
your child's foot too tight, this could
hurt him or cause him to get cramp
during the ride.
DANGER! After having fixed
the footrests for your child, it is very
important to check that the child
cannot release its feet on its own: lift
up your child's leg to check it is well
secured.
DANGER! It may occur that your
child is able to pull his foot out of his
shoe, which remains attached to the
footrest; to prevent this from happe-
ning, always check that your child's
shoes are correctly fastened onto the
feet.
Instructions for use and assembly
Page 70
16
1
A
B
2
A B
3
LIB093R01EU Edition: 03-2010
Chapter 7 Child's bicycle seat OKBABY BODY GUARD
Figure 3a:
Fasten the safety belt onto the child
Adjust the height and length of the
belts according to the size of the
child.
Setting the height of the belt:
extract the belt to adjust the height,
inserting the buckle a little at a time
behind the backrest towards the ope-
ning (fig. 3b e 3c). Select the top and
bottom openings to fasten the belts
according to the height of the child.
Setting the length of the belt:
Adjust the length of the belts by
moving the clasps on the belt. The
belts must be fastened firmly without
them being too tight for the child.
WARNING! Always adjust the seat
belts according to the height of the
baby (fig. 3d).
Fastening the safety belt system:
Fastening the belt clasp.
Check that the belt clasp clicks shut
properly, and then pull the belt.
DANGER! The fastening of the
belt is an important safety precaution
and must always be in place.
Always check that it is correctly faste-
ned before every trip! The life of a
child who is not attached is in danger!
Figure 4:
Press simultaneously the two press-
buttons (front and rear) on the clasp.
The clasp will open.
IMPORTANT/NOTE: Releasing the
clasp is not that easy to guarantee
maximum levels of safety.
Figure 5:
Removing the child seat.
Press the release button (7) on the
fastening block and remove the child
seat.
Instructions for use and assembly
Page 71
3a
CLICK
3b 3c
3d 4
5
LIB093R01EU Edition: 03-2010