Safety Notes; Important Notes; Functions; Operating Instructions - Trix V60 Serie Manual De Instrucciones

Safety Notes

• This model is only to be used with the operating system it
is designed for.
• Analog max. 15 Volts DC, digital max. 22 volts AC.
• This model must not be supplied with power from more
than one power pack.
• Please make note of the safety notes in the instructions
for your operating system.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the model is to
be run in conventional operation. The 611 655 interference
suppression set is to be used for this purpose. The interfe-
rence suppression set is not suitable for digital operation.
• WARNING! Sharp edges and points required for operation.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• The LEDs in this item correspond to Laser Class 1 accor-
ding to Standard EN 60825-1.

Important Notes

• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• This specially prepared model is an exclusive version,
which reproduces the condition of the original after many
years of operation in wind and weather.
The artificial weathering was separately applied with
careful hand work by experienced artisans. Despite a final
fixing of the colors with varnish, this additional application
of color does not form a homogeneous, hard coating.
Therefore, please handle the model with special care
and avoid, scratching, rubbing, or wiping the surface and
the details. Please do not use liquid cleaners or cleaning
solutions.
Please note that the spare parts for this model weathered
at the factory are only available in non-weathered version.
• Please see your authorized Trix dealer for repairs or spare
parts.
• The warranty card included with this product specifies the
warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html

Functions

• This model comes equipped with a Trix
connector for digital operation and can have
21
the Märklin locomotive decoder 60972 installed
in it.
• Trix motor vehicles must not be operated on digital
systems without an built-in engine decoder (Motor can be
damaged!).
• Headlights change over with the direction of travel.
• Minimum radius for operation is 360 mm / 14-3/16".

Operating Instructions

Information about retrofitting a digital decoder:
This locomotive has an electronic circuit (item no. E281412)
plugged into the digital connector instead of a connector
plug on the basic circuit board. This electronic circuit is
only required in analog operation. It must be removed when
retrofitting the locomotive with a digital decoder. See also
Page 19.
5