Using The Cooking Zones; Powerboost; Heat Setting - AEG IPE84531FB Manual De Instrucciones

Heat setting

6 - 9

5.3 Using the cooking zones

CAUTION!
Do not place hot cookware on
the control panel. There is a risk
of damage to the electronic
parts.
Place the cookware in the centre of the
selected zone. Induction cooking zones
adapt to the dimension of the bottom of the
cookware automatically.
Once the pot is detected, the heat setting 0
comes on.
5.4 Heat setting
1. Press the desired heat setting on the
control bar. You can also move your
finger along the control bar to set or
change the heat setting for a cooking
zone.
2. To deactivate a cooking zone, press 0.
104 ENGLISH
The hob deactivates
after
1.5 hours
Once you place a pot on the cooking zone
and set the heat setting, it remains the same
for 50 seconds after you remove the pot. The
control bar blinks for the second half of that
time. If you place the pot on the cooking zone
again within this time, the heat setting
reactivates. Otherwise the cooking zone
deactivates.

5.5 PowerBoost

This function activates more power for the
appropriate induction cooking zone,
depending on the cookware size. The
function can be activated only for a limited
period of time.
Touch to activate the function for the
cooking zone.
The function deactivates automatically.
For maximum duration values,
refer to "Technical data".
5.6 Timer
Count Down Timer
Use this function to specify how long a
cooking zone should operate during a single
cooking session.
First set the heat setting, then set the
function.
1. Touch to activate the function or
change the time.
The timer digits
and come on the display.
If the timer is not set,
after 3 seconds.
2. Touch or
minutes).
After 3 seconds, the timer starts to count
down automatically. The indicators
disappear.
When the time comes to an end, a signal
sounds and flashes. To stop the signal,
touch .
and the indicators
and disappear
to set the time (00 - 99
, and