Residual Risks; Assembly; Unpacking; Commands And Control Instruments - Stiga ST 201 Manual De Instrucciones

(Translation of the Original Instructions)

4 RESIDUAL RISKS

Even when the snow thrower is used
in accordance with the manufacturer's
instructions, there are still some risks
which could not be eliminated in the de-
sign phase. Depending on the type and
construction of the machine, there may
be the following potential risks:
a. Damage to hearing if suitable hearing
protection is not worn when using the
machine.
b. D amage to sight if suitable eye
protection is not worn when using the
machine.
WARNING - The noise and vibration
levels shown in these instructions are
the maximum levels for use of the ma-
chine. Prolonged use, poor or total lack
of maintenance and the type of snow
(light or heavy) being cleared signif-
icantly affect the level of noise emis-
sions and vibrations. Consequently, it
is necessary to take preventive steps to
eliminate possible damage due to high
levels of noise and stress from vibra-
tion. Maintain the machine well, wear
ear protection devices, and take breaks
while working.

5 ASSEMBLY

Do not use the machine until all the in-
dications provided in the "ASSEMBLY"
section have been carried out.
5.1

UNPACKING

4. Consult the instructions found in the pack-
aging.
5. Take the snow thrower out of the box.
6. Place it on a clean and level surface ready
for assembly.
Dispose of the box and packaging accord-
ing to local regulations.
5.2 ASSEMBLY
Assemble the snow thrower as follows.
1. Assemble the black plastic sleeve (4:A) on
the shank until the tap locks in the shank
hole.
2. Align the stem with the auger casing so that
the ridge (5:A) matches the groove (5:B).
ENGLISH
3. Slide the stem into the auger casing and in-
sert the two screws with nuts. Tighten using
a Philips screwdriver (6).
4. Align the square insert of the stem into the
relative hole on the handle (7).
5. Slide the shank and the handle together until
the tap locks in the shank (8) (position indi-
cated by the decal affixed to the stem).
6. Screw on and tighten the plastic ring nut (9).
6 COMMANDS AND CONTROL
6.1

STARTER SWITCH LOCKING DEVICE

(1:B)
Prevents inadvertent activation of the starter
switch.
Press the button (1:B) to release the starter switch.
6.2 STARTER SWITCH (1:C)
Starts the motor.
Press the lever (1:C) to start the machine.
The lever can be activated only if the starter
switch locking device (1:B) is pressed.
6.3 HANDGRIP LOCKING DEVICE (1:F)
Handgrip locking lever.
Act on the knob (1:F) to lock the handgrip in the
required position.
6.4 HANDGRIP (1:G)
6.5 STEM LOCKING DEVICE (1:H)
Stem locking.
The length of the stem is adjustable. Act on the
knob (1:J) to lock the stem (1:H) in the required
position.

7 START-UP AND OPERATION

7.1

GENERAL

Never start the motor until all the above measures
under 'ASSEMBLY' have been carried out.
Never use the snow thrower without
first reading and understanding the en-
closed instructions and all the warning
and instruction stickers on the snow
thrower and in these instructions.
INSTRUMENTS
EN
9