Assembly; Use - Imetec Q5901 Instrucciones De Uso

• Take the cable out of its housing in the base of the appliance.
• Connect the power plug to the mains socket.
EN
How to prepare the bags on the roll
• Open the lid and raise the cutter. Pull out a short length of the roll and then lower the cutter.
• Cut the extracted piece by sliding the cutter.
• Position the open end of the cut piece along the sealing bar.
• Close the lid and press its sides slightly down with the palms of your hands, locking it at the
same time by pressing the lid open/close buttons with your fingers.
• Select the required sealing time by pressing the sealing time button.
• Press the sealing button. The indicator light will turn orange. After completing the sealing
operation, the machine will emit an acoustic signal. The indicator light will turn green and
the cover will be unlocked.
• Take the bag out and check the seal.
NOTE: a good seal will look clean and transparent. If the seal is
uneven, incomplete or wrinkled, cut it and repeat the procedure.
WARNING!
signs of damage.
WARNING!
• Connect the power plug to the mains socket.
• Raise the lid by pressing the lid open/close buttons on the sides of the machine.
• Position the bag with its open side in the basin. Leave about 4-5cm of space in the upper
part of the bag to ensure a better vacuum level.
• Close the lid and press its sides slightly down with the palms of your hands, locking it at the
same time by pressing the lid open/close buttons with your fingers.
For automatic operation: press the automatic operation and switch-off button. The vacuum-
packer machine will perform the vacuum packing and sealing automatically. In this way, the
machine works with the pre-set parameters (high vacuum level and standard sealing time).
Personalised adjustment: select the required vacuum level and sealing speed by pressing
the vacuum level and sealing speed buttons respectively. To start, press the automatic
operation and switch-off button.
For manual operation: the "Manual" function can be used to check the time and required
vacuum pressure; this will avoid any damage to delicate foodstuffs, or may be handy when
you want to store foods with a liquid part (to prevent the liquid from being sucked out).
• Position the bag with its open side in the basin. Leave about 4-5cm of space in the upper
part of the bag to ensure a better vacuum level.
16

ASSEMBLY

USE

DO NOT use this appliance if there are visible
DO NOT let liquids or dust enter the pump.