Würth EWS 10-125 COMPACT Traducción Del Manual De Instrucciones De Servicio Original página 27

Safety hood for grinding
Intended for use in work with roughing discs, mul-
ti-disc grinding wheels, diamond cut-off wheels.
Press and hold locking lever [14].
■
Push safety hood [6] onto the spindle neck as
■
shown.
Adjust the position of the safety hood to the
■
position of the hand on the machine. Turn the
safety hood until it is in the desired position.
3 The closed side of the safety hood must be
facing towards the operator.
Release the locking lever and turn the safety
■
hood until the locking lever audibly engages.
Check that the safety hood is secure: The lever
■
must be engaged and it must not be possible to
turn the safety hood.
Attaching grinding wheel
WARNING!
Risk of severe injuries.
¾ Pull the mains plug out of the
plug socket before all tooling
operations.
¾ The machine must be switched off
and at a standstill.
Locking spindle
Press in spindle locking knob [13] and turn the
■
spindle by hand until the spindle locking knob
audibly engages.
Fitting abrasive wheel or disc
Push supporting flange [11] onto the
■
spindle [12].
3 It is fitted correctly when it cannot be turned on
the spindle.
Push abrasive wheel [10] onto the supporting
■
flange [11].
• The grinding wheel must rest uniformly on the
supporting flange.
• The sheet metal flange of cut-off wheels must
rest on the supporting flange.
CAUTION!
Risk of severe injuries
¾ For safety reasons, using the cut-off
wheel safety hood for all work with
cut-off wheels.
Two-hole nut (depending on
configuration)
Tightening the two-hole nut
Attention!
The 2 sides of the two-hole nut [8] are different.
Screw the two-hole nut onto the spindle as
■
follows:
With thin grinding wheels
• The collar of the two-hole nut [8] faces up-
wards so that the thin grinding wheel can be
securely clamped.
With thick grinding wheels
• The collar of the two-hole nut [8] faces down-
wards so that the two-hole nut can be securely
screwed onto the spindle.
Lock the spindle.
■
Tighten the two-hole nut in clockwise direction
■
using the two-hole wrench [7].
Loosening the two-hole nut
Lock the spindle.
■
Unscrew the two-hole nut [8] in anti-clockwise
■
direction using the two-hole wrench [7].
27