ISO DIN radio provision with pocket
1.
Remove the metal "DIN" sleeve and
trim ring from the aftermarket radio.
2.
Secure the radio brackets to the
radio housing using the (4) 3/8"
Phillips screws provided. (Figure A)
3.
Slide the radio into the bracket/
housing assembly and secure
using the screws supplied with the
radio. (Figure B)
4.
Locate the factory wiring harness
and antenna connector in the dash.
Metra recommends using the
proper mating adapters from Metra
and/or AXXESS.
5.
Reassemble the dash in reverse
order of disassembly.
Kit Assembly
(Figure A)
(Figure B)
®
99-7614
ISO DDIN radio provision
1. Remove the brackets from the
factory radio.
2. Secure the brackets to the
aftermarket radio using the screws
supplied with the aftermarket
radio. (Figure A)
Note: 99-7614 radio brackets can
be used in place of the factory
brackets.
3. Locate the factory wiring harness
and antenna connector in the
dash. Metra recommends using
the proper mating adapters from
Metra and/or AXXESS.
4. Place the ISO DDIN trim plate on
the front of the radio. (Figure B)
5. Reassemble the dash in reverse
order of disassembly.
7
(Figure A)
(Figure B)