General Information - Agilent Technologies TV70 Manual De Instrucciones

17 Instructions for Use

General Information

General Information

This equipment is destined for use by professionals. The user should
read this instruction manual and any other additional information
supplied by Agilent before operating the equipment. Agilent will not
be held responsible for any events occurring due to non-compliance,
even partial, with these instructions, improper use by untrained
persons, non-authorized interference with the equipment or any
action contrary to that provided for by specific national standards.
The TV70 Navigator controller can be used with the Turbo-V70/D/LP
pumps. It is equipped with auxiliary connectors with allow to supply
a supplementary fan, to control the vent valve and to drive it in
remote mode by a host computer connected by a serial line (RS232 or
RS485). The following paragraphs contain all the information
necessary to guarantee the safety of the operator when using the
equipment. Detailed information is supplied in the appendix
"Technical Information".
This manual uses the following standard protocol:
The caution messages are displayed before procedures which, if not followed,
CAUTION!
could cause damage to the equipment.
The warning messages are for attracting the attention of the operator to a
WARNING! particular procedure or practice which, if not followed correctly, could lead to
serious injury.
The notes contain important information taken from the text.
NOTE
142/182 Controller TV70 Navigator User Manual / 87-900-956-01 (G)