Publicidad
16
Instructions for Use
General Information
General Information
This equipment is destined for use by professionals. The user should
read this instruction manual and any other additional information
supplied by Agilent before operating the equipment. Agilent will not
be held responsible for any events occurring due to non-compliance,
even partial, with these instructions, improper use by untrained
persons, non-authorised interference with the equipment or any
action contrary to that provided for by specific national standards.
The Turbo-V 1000HT PCB controller is a microprocessor-controlled,
solid-state, frequency converter with self-diagnostic and self-
protection features.
It incorporates all the facilities required for the automatic operation
of the Turbo-V 1000HT PCB pump series.
The controller drives (within ten steps) the Turbo-V 1000HT PCB
pump during the starting phase by controlling the voltage and
current respect to the speed reached by the pump.
Remote start/stop, pump status signals, forepump start/stop,
interlock control (for pressure switch, water flow switch, etc.)
capability, are provided via auxiliary connectors. The controller
needs to be powered by an external transformer (not supplied with
the PCB).
An hand held terminal is available as an option to control and
display the controller operation. The following paragraphs contain all
the information necessary to guarantee the safety of the operator
when using the equipment. Detailed information is supplied in the
appendix "Technical Information".
194/262
Turbo-V 1000HT PCB Controller User Manual / 87-900-906-01
(F)
Publicidad
Capítulos
