General Information - Agilent Technologies Turbo-V 700HT Manual De Instrucciones

16 Instructions for Use

General Information

General Information

This equipment is destined for use by professionals. The user should
read this instruction manual and any other additional information
supplied by Agilent before operating the equipment. Agilent will not be
held responsible for any events occurring due to non-compliance, even
partial, with these instructions, improper use by untrained people, non-
authorized interference with the equipment or any action contrary to
that provided for by specific national standards. The Turbo-V 700HT
series controllers are microprocessor-controlled, solid-state, frequency
converters with self-diagnostic and self-protection features.
The controllers drive (within ten steps) the Turbo-V 700HT pump during
the starting phase by controlling the voltage and current respect to the
speed reached by the pump. They incorporate all the facilities required
for the automatic operation of the Turbo-V 700HT pump series.
Remote start/stop, pump status signals, forepump start/stop, interlock
control (for pressure switch, water flow switch. etc.) capability, are
provided via auxiliary connectors. The following paragraphs contain all
the information necessary to guarantee the safety of the operator when
using the equipment. Detailed information is supplied in the appendix
"Technical Information".
224/304 Turbo-V 700HT Controller User Manual / 87-900-877-01 (F)