Evolution EVO-SYSTEM 1000L Manual De Instrucciones página 213

Fig 12
Fig 13
Fig 14
Fig 15
Note: If either fluid levels require 'topping up' follow previously
outlined instructions (Refer to 'Checking Oil Level' and 'Safety
Instructions For Fuel Filling'). Do not try to start the engine
until fluid levels have been checked and adjusted and a visual
safety check has been completed.
1. Starting your EVO-SYSTEM Engine
Note: A visual safety check should be carried out before
attempting to start the engine. Particularly check for any fuel
or oil leaks, the integrity of accessory attachment and the
stability of the machine.
Rectify any faults found before attempting to operate the
machine.
• Ensure that the transportation wheels are locked by applying
the wheel brake.
• Turn the fuel tap lever to the 'On' position. (Fig. 11)
• Set the choke lever to the 'Choke On' position. (Fig. 12)
• Turn the engine ignition switch to the 'ON' position. (Fig. 13)
• Steady the EVO-SYSTEM Engine by holding the external
frame at a convenient point.
• Use your other hand to grip the recoil starter cord handle.
(Fig. 14)
• Pull the recoil starter cord slowly until resistance is felt
indicating that the starter is engaged.
• When resistance is felt pull the cord sharply.
• Continue this procedure until the engine starts.
• After starting the engine gradually return the choke lever to
the open position. (Fig. 15)
• The engine 'warm-up' period can take a few minutes but
this will depend upon ambient temperatures, operating
conditions etc. Operator discretion will be required to
determine when the engine is running efficiently and at its
full operating temperature.
Note: When using the generator accessory the engine must
be run at 3150 min the factory set governed speed.
-1
2. Stopping your EVO-SYSTEM Engine
Note: The procedure for stopping the engine can be influenced
by the accessory that is connected.
If the generator accessory has been connected to the engine,
it is important that before stopping the engine all electrical
loads are disconnected from the generator AC outlet sockets.
Failure to do so may cause damage to any connected
appliances. See the relevant 'Instruction Manual(s)' for any
specific requirements or advice regarding machine shut down.
www.evolutionpowertools.com
CZ
®
DA
DE
EL
ES
FI
FR
GB
IT
NL
NO
PL
PT
RU
SK
SV
213