SSS Siedle CA 812-1 Manual De Instrucciones página 5

English
Application
Compact Audio door station with 1,
2 or 4 call buttons. With the basic
functions calling, speech and door
release.
Application
The SET door loudspeaker CA 812-...
is exclusively designed for use within
the SET CA 812-... Any other appli-
cation is deemed not in accordance
with its intended use and exonerates
the manufacturer from any liability.
Electrical voltage
Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
Electrostatic charging
As a result of electrostatic charging,
direct contact with the circuit board
can result in destruction of the
device. Direct contact with the circuit
board must therefore be avoided.
Scope of supply
• Door station compact audio
CA 812-...
• Siedle screwdriver
• This product information
Mounting
1 Unscrew the front of the housing.
To do this, release the Siedle screw
on the underneath of the housing.
Hinge the front of the housing
forward.
2 Surface mounting the door sta-
tion. Recommended mounting
height appr. 1.50 m /4.9 ft. to centre
device. Please note: The cable is
inserted in the lower area of the
base plate!
3 Strip back the installation cable
close to the wall (appr. 10 mm) and
insert the cores into the base plate.
Fasten the base plate using 4 screws.
Close the two openings at the top
using rubber stoppers. Install in
accordance with the terminal dia-
gram. The cores may only be laid in
the admissible installation space.
4 Depending on the installation
environment, it may be necessary
to change the door station speech
volume in order to permit clear
speech transmission.
5 Hook the front of the housing
onto the base plate at the top and
close. Tighten the screw on the
underneath of the housing.
Lettering
6 Open the nameplate from the
outside, for example using a flat
bladed screwdriver, and carefully
remove the inscription insert. To
insert the nameplate, lock into place
by exerting light pressure.
7 Info sign from the inside, e.g.
open using flat blade screwdriver
and remove inscription field. To
insert, clip in the info sign exerting a
slight pressure.
Terminal assignment
1 Basic terminal 1+n
7.1 Call button 1 (upper button)
7.2 Call button 2
7.3 Call button 3
7.4 Call button 4
b/c supply 12 V AC
TR Door release contact max.
15 V AC, 30 V DC, 2A
Li Light contact max. 15 V AC,
30 V DC, 2A
D+/D- Connection of the
CTÖ 602-0
Commissioning
Installation and commissioning are
described in the product information
sheet for SET CA 812-... (enclosed
with the Compact Audio
SET CA 812-...).
Specifications
Contact type: 2 n.o. contact
max. 15 V AC/30 V DC, 2 A
Ambient temperature:
-20°C to +55°C
Protection system: IP 54
Dimensions (mm) W x H x D:
82 x 226 x 33
3