Publicidad
Idiomas disponibles
Idiomas disponibles
English
Mounting
Application
Compact-select video door station
for surface mounting with 1, 2
or 4 call buttons. With the basic
functions calling, speech, vision and
door release. Connection to Siedle
In-Home bus: Video.
Electrical voltage
Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
Electrostatic charging
As a result of electrostatic charging,
direct contact with the circuit board
can result in destruction of the
device. Direct contact with the circuit
board must therefore be avoided.
Important installation instruc-
tions
The following installation situations
must be avoided without fail:
Direct ajour light
Direct sunlight
Extremely bright picture background
Highly reflective walls on the oppo-
site side of the door station
Lamps or direct light sources
Scope of delivery
Compact-select video door station
Allen key size 2.5
4 distance washers
This product information sheet
Mounting
1
Surface mounting the door
station. Recommended mounting
height appr. 1.50 m /4.9 ft. to centre
device. Please note: The cable is
inserted in the lower area of the
base plate!
2
Unscrew the front of the housing.
To do this, release the two Allen
screws on the underneath of the
base plate by at least 8 turns. Hinge
the front of the housing forward.
3
If the mounting surface is very
uneven, the provided distance
washers can be used to compensate
differences.
4
Strip back the installation cable
close to the wall (appr. 10 mm) and
insert the cores into the base plate.
Fasten the base plate using 4 screws.
5
The pick-up angle of the camera
can be mechanically preadjusted on
the vertical and horizontal by appr.
30° depending on the mounting
situation. To change the pick-up
direction of the camera, loosen
the two cross-head screws slightly.
Position the camera in the required
direction. Then fix the required
position using the two cross-head
screws.
6
Depending on the installation
environment, it may be necessary
to change the door station speech
volume in order to permit clear
speech transmission.
7
Hook the front of the housing
onto the base plate at the top and
close. Screw the two Allen screws
underneath into the base plate with
at least 8 turns.
Lettering
8
Open the name plate from the
outside, for example using a flat
bladed screwdriver, and carefully
remove the name plate. To insert
the name plate, lock into place by
exerting light pressure.
Terminal assignment
TaK/TbK
In-Home bus: Video
camera branch
Tö
Door release contact
max. 15 V AC,
30 V DC, 2A
c/b
supply 12 V AC for
heating
Commissioning
Installation and commissioning pro-
cedures are described in the system
manual (enclosed with Bus Video
Line Rectifier BVNG 650-...).
Technical data
•
Lens 3.7 mm
•
Mounting height appr. 1.50m
•
Ambient temperature
-20° C to +40°C
•
Protection system IP 54, IK 8
•
Dimensions (mm) W x H x D
100 x 340 x 38
3
Publicidad
