Usable Discs - Rupes ER123TE Instrucciones Original De Uso Y Manutención

REPLACING THE ABRASIVE PAPER DISCS
- Used discs can be removed by simply tearing them off;
- new velcro discs are mounted by simply pressing them into the
pad, making sure that the holes cut in the paper disc coincide
with those in the pad.

USABLE DISCS

Ø 150 mm velcro abrasive paper discs with dust extraction holes.
MAINTENANCE
All maintenance operations are carried out with the power supply
disconnected.
Empty the dust collections bag (9) frequently.
At the end of each work session, or when required, remove any
dust from the body of the tool using a jet of compressed air,
paying particular attention to the motor ventilation slots.
To replace the power cord refer to the data sheet enclosed with
this manual.
No other maintenance operations must be undertaken by the
user.
Maintenance and cleaning of the inner parts, like brushes, ball
bearings, gears etc. or others, must be carried out only by an
autorized customer-service workshop.
ELECTRIC SAFETY - LOW TENSION
The tests have been carried out in accordance with the standard:
EN 60745-1 safety of hand-held electric motor operated tools
EN 60745-2-4 particular requirements for sanders.
RADIO SUPPRESSION
The tools are suppressed in accordance for the prevention and
elimination of radio disturbances measured in accordance with
standard: EN55014-1+EN55014-2; EN61000-3-2+EN61000-3-3.
NOISE
The noise level produced is
ER123TE: 74 dB (A) / K = 3 dB(A)
ER125TE: 74 dB (A) / K = 3 dB(A)
10
ER153TE: 75 dB (A) / K = 3 dB(A)
ER155TE: 75 dB (A) / K = 3 dB(A)
measured according to standard EN 60745-1.
MEAN ACCELERATION VALUE
The mean quadratic acceleration value is
2
ER 123TE: 1.85 m/s / K= 0,5 m/s
2
ER 125TE: 2.0 m/s / K= 0,5 m/s
2
ER 153TE: 2.0 m/s / K= 0,5 m/s
2
ER 155TE: 2.5 m/s / K= 0,5 m/s
measured with according to standard EN 60745-1.
GUARANTEE
All tools manufactured by RUPES Spa are guaranteed for 12
months from the date of purchase against fabrication and mate-
rial defects.
All tools must be used only with RUPES original accessories and
spare parts: we refuse all responsibility for damages or accidents
caused by non-observance of this rule which will also cause the
termination of the guarantee.
The guarantee will no longer be valid if the instructions contained
in this booklet are not followed, if the tool is used for purposes
other than that for which it is intended, if it is dismantled, interfe-
red with in any way or damaged due to neglect.
The guarantee will be made valid by filling-in the form on the
inside back cover of this instruction booklet.
If the tool is found to be defective or malfunctions, it should be re-
turned carriage free in one piece in its original packing together
with the guarantee certificate to the manufacturer or to one of the
Assistance Centres listed in the appendix to this booklet.
The guarantee does not automatically imply replacement of the
tool.
RUPES Spa reserves the right to make any technical or design
modification to its products without prior notice.
The manufacturer is not liable for any print errors.
This document voids and replaces previous ones.
2
2
2
2