General Warnings; Correct Usage - Rupes ER123TE Instrucciones Original De Uso Y Manutención

TECHNICA DATA
TYPES
PROTECTION CLASS
OPERATING VOLTAGE
ABSORBED CURRENT
ABSORBED POWER
ELECTRONIC SPEED CONTROL
REOTATION/min (r.p.m.)
ORBITAL DIAMETER mm
PAD DIAMETER mm
PAD TYPE
SVACUUM SYSTEM
WEIGHT kg

GENERAL WARNINGS

The safety and accident prevention instructions are reported
in the "SAFETY INSTRUCTION" booklet which forms an
integral part of these documents. This OPERATING
INSTRUCTION MANUAL indicates the additional information
required specifically for use of the tool.

CORRECT USAGE

This tool is designed to be used as a sander. Read all the
warnings, instructions, indications provided on drawings and
specifications supplied with this tool.Failure to comply with all
the instructions provided below may cause electrical shocks, fires
and/or serious injuries.
This tool is not intended to be used for metal brushing,
polishing and cutting operations. The use of this tool for
unintended applications may cause hazards and injuries to
people.
Do not use accessories that are not specifically designed for
the intended use of the tool or that have not been
recommended by the manufacturer. The fact that an accessory
can be fixed to the tool does not imply that it can be used safely.
8
ER123TE ER125TE
II II
230 V - 50 Hz 230 V - 50 Hz
1,5 A 1,5 A
320 W 320 W
YES YES
4.000 ÷ 10.000 4.000 ÷ 10.000
3 5
125 125
VELCRO FACED VELCRO FACED
INTEGRAL INTEGRAL
1,5 1,5
The rated speed of the accessory must be at least equivalent
to the maximum speed specified on the tool. Using the
accessories at speeds above the rated one, may cause them to
break or be projected into the air.
The external diameter and thickness of the accessory must
match the specifications of the electrical tool. Accessories with
incorrect dimensions cannot be adequately protected or
controlled.
The configuration of accessories must match the tool. The use
of accessories that cannot be perfectly fitted on the tool may
result in imbalance, excessive vibrations and in the impossibility
of controlling the tool.
Do not use damaged accessories. Before use, inspect all the
accessories. Inspect the supporting pads and verify there are
no cracks, tears or excessive wear. If the tool or accessory
has fallen, verify that it is not damaged or install a new
accessory. After inspecting or installing an accessory, move
to a safe distance with any other person present and operate
the tool at maximum speed without load for one minute.
Damaged accessories generally break during this test period.
ENGLISH
ER153TE ER155TE
II
230 V - 50 Hz 230 V - 50 Hz
1,5 A 1,5 A
320 W 320 W
YES YES
4.000 ÷ 10.000 4.000 ÷ 10.000
3
150 150
VELCRO FACED VELCRO FACED
INTEGRAL INTEGRAL
1,5 1,5
8
II
5