Control Pannels - Sagi XE70 Instrucciones Originales - Manual De Uso E Instalación

CONTROL PANNELS

4 5 6
1 2 3
ON/SBY/ENTER key
Press and release this key to check/change the appliance operation
setpoint.
Press this key for 3 seconds and release it as the display shows the
[Sby] to set the appliance to the stand-by mode.
Hold this key pressed for over 5 seconds (thus avoiding the Sby
label) to gain access to the user parameters list.
When holding device in stand-by pressed [the display shows Sby],
the controller turns on.
UP and DOWN keys
These keys allow to increase or decrease the value of the parameter
to be changed.
Press these keys to display the min and max temperature recorded
(if available) and any alarm activated.
With the keyboard locked, press these keys simultaneously to
unlock.
Press UP for 3 seconds to activate the Hyper Cold function.
Press DOWN for 3 seconds to de-activate the Hyper Cold function.
MENU key
Press this key for 3 seconds to activate/de-activate the appliance
smart function input.
DEFROST ICON
Led on: defrost in progress
Led blinking: defrost activation delay or dripping in progress
Led blinking at high frequency: alarm memorized
FAN ICON
Led on: room fans activated
Flashing LED: post-defrosting fans activation delay
COMPRESSOR ICON
Led on: compressor activated
Led blinking: compressor activation delay
menu
4
19
POS DESCRIPTION
1 ON/SBY/ENTER key
2 DOWN key
3 UP key
4 MENU key
5 DEFROST ICON
6 FAN ICON
COMPRESSOR
7
ICON