Presetting the RDS
stations with the AF and
TA data
When you preset RDS stations, the unit stores
each station's data as well as its frequency, so
you don't have to turn on the AF or TA
function every time you tune in the preset
station. You can select a different setting (AF,
TA, or both) for individual preset station, or
the same setting for all preset stations.
Presetting the same setting for all
preset stations
1
Select an FM band (page 10).
2
Press (AF/TA) repeatedly to select either
"AF on," "TA on" or "AF TA on" (for both
AF and TA functions).
Note that selecting "AF TA off" stores not
only RDS stations, but also non-RDS
stations.
3
Press (SHIFT), then press (4) (PLAY
MODE) repeatedly until "B.T.M" appears.
4
Press (5) (n) until "B.T.M" flashes.
5
Press (SHIFT).
Presetting different settings for
each preset station
1
Select an FM band, and tune in the
desired station.
2
Press (AF/TA) repeatedly to select either
"AF on," "TA on" or "AF TA on" (for both
AF and TA functions).
3
Press the desired number button and
hold until "MEM" appears.
Repeat from step 1 to preset other stations.
Tip
If you want to change the preset AF and/or TA
setting after you tune in the preset station, you
can do so by turning the AF or TA function on or
off.
Recording the traffic
announcements
—Traffic Information Replay (TIR)
You can listen to the latest traffic
announcements by recording them. The unit
automatically records and stores up to eight
traffic announcements. If the recording
exceeds eight minutes, the recorded
announcements are updated, so you can
always hear the latest information.
The TIR function turns on the unit
automatically and records the traffic
announcements for up to two hours before and
after a preset time.
Presetting the time and the station
1
Press and hold (TIR) until "TIR" lights up
in the display.
2
Press (5) (n) repeatedly until "TIR on"
appears.
REG
3
Press (TIR) repeatedly until the time
indication appears.
REG
1 Set the hour by rotating the dial.
REG
continue to next page n
EN
15