Storing A Surround Effect Onto The Cds; Digital Signal Processor (Dsp) Custom; File - Sony XR-C9100R Manual De Instrucciones

1
Press (SOURCE) to select a source (tuner,
tape, CD, or MD).
2
Press (SOUND) repeatedly until "SUR"
appears.
3
Rotate the dial to select the desired
surround menu.
The surround menu appears in the order
shown above.
After three seconds, the display returns to
the normal playback mode.
Adjusting the effect level
1
Press (SOURCE) to select a source (tuner,
tape, CD, or MD).
2
Press (SOUND) for two seconds.
SUR
3
Rotate the dial to select until the desired
surround menu appears.
SUR
4
Press (5) ( n).
SUR
5
Rotate the dial to adjust the level.
You can adjust the level from 0 to 100%.
Increase the level to enhance the effect.
SUR
6
Press (SOUND) for two seconds.
Storing a surround effect
onto the CDs

— Digital Signal Processor (DSP) Custom

File (CD unit the with custom file function)
Once you have registered the desired surround
menu onto the discs, you can enjoy the same
surround menu every time you play them.
(Only when you have labeled a disc by the
Custom File function.)
1
During CD playback, press (PTY/LIST) for
two seconds.
2
Press (PTY/LIST) until the surround menu
appears.
DSP custom file mode
3
Rotate the dial to select the desired
surround menu.
4
Press (PTY/LIST) for two seconds.
After the effect setting is complete, the
display returns to the normal playback
mode.
Playing the disc with the stored
surround menu
1
Press (SHIFT), then press (4) (PLAY
MODE) repeatedly until "D.File"
appears.
2
Press (5) ( n) to select "D.File on."
After five seconds, the display returns to
the normal playback mode.
3
Press (SHIFT).
To cancel to play the disc with stored surround
menu, select "D.File off" in step 2 above.
EN
33