Temperature & Humidity; Data Clearing; Backlight; Pointing 5-In-1 Sensor To The South - Emos ESW5003 Manual Del Usuario

TEMPERATURE & HUMIDITY
COMFORT INDICATION
The comfort indication is a pictorial indication based on indoor air temperature and humidity in an attempt to
determine comfort level.
Note:
- Comfort indication can vary under the same temperature, depending on the humidity.
- There is no comfort Indication when temperature is below 0°C(32°F) or over 60°C (140°F).

DATA CLEARING

During installation of the wireless 5-IN-1 sensor, the sensors were likely to be triggered, resulting in erroneous
rainfall and wind measurements. After the installation, user may clear out all the erroneous data from the
Display Main Unit, without needing to reset the clock and re-establish pairing. Simply press and hold the [
HISTORY ] key for 10 seconds. This will clear out any data recorded before.

BACKLIGHT

The main unit backlight can be adjust, using the [ HI / LO / AUTO ] sliding switch to select the appropriate
brightness:
- Slide to the [ HI ] position for the brighter backlight.
- Slide to the [ LO ] position for the dimmer backlight.
- Slide to the [ AUTO ] position for the auto adjust backlight that according to environment light level.

POINTING 5-IN-1 SENSOR TO THE SOUTH

The outdoor 5-IN-1 sensor is calibrated to be pointing to North by default. However, in some cases, users may
wish to install the product with the arrow pointing towards the South:
1. First install the outdoor 5-IN-1 sensor with its arrow pointing to the South.
2. On the Display main unit, press and hold the [ WIND ] key for 8 seconds until the upper part (Northern
Hemisphere) of the compass lights up and blinking.
3. Use [ ] key / [ ] key to change to lower part (Southern Hemisphere).
4. Press the [ WIND ] key to confirm and exit
Note:
Changing from hemisphere setting will automatically switch the direction of the moon phase on the display.
Too cold Comfortable
Northern hemisphere
Too hot
Southern hemisphere
16