Emos ESW5003 Manual Del Usuario página 8

Step 3
Insert the other side of the pole to the square hole
of the plastic stand.
Note:
Ensure the pole and stand's indicator align.
Step 4
Place the nut in the hexagon hole of the stand,
then insert the screw in other side and then tighten
it by the screw driver.
Install the wireless 5-IN-1 sensor
in an open location with no
obstructions above and around the
sensor for accurate rain and wind
measurement. Install the sensor
with the smaller end facing the
North to properly orient the wind
direction vane.
Secure the mounting stand and
clamps (included) to a post or
pole, and allow minimum 1.5m off
the ground.
A. Mounting on pole (Pole Diameter 1"~1.3"
(25~33mm)
Add rubber
pads before
mount on
the pole
B. Mounting on the railing
8
Point to
NORTH
1.5 meter off
the ground