Replace The Cutting Line; Transportation And Storage; Store The Machine; Troubleshooting - GreenWorks STA806 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

10.4

REPLACE THE CUTTING LINE

NOTE
Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of 0.065" (1.65 mm)
diameter.
1. Cut two pieces of cutting line approximately 3m long of
each.
2. Bend one end of the line 1/4 of an inch (6.35mm) .
3. Put the lines into the anchor holes of the spool.
4. Wind the cutting lines around the spool tightly in the
indicated direction.
5. Put the cutting lines in the guide slots.
6. Do not wind the cutting line beyond the edge of the spool.
11
TRANSPORTATION AND
STORAGE
WARNING
Remove the battery pack from the machine before

transportation and storage.

11.1

STORE THE MACHINE

Remove the battery pack from the machine.
Make sure that children cannot come near the machine.
Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
NOTE
English
Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine for any
damage.
12

TROUBLESHOOTING

Problem
Possible Cause
The ma-
No electrical con-
chine does
tact between the
not start
machine and the
when you
battery pack.
push the
trigger.
The battery pack is
depleted.
The lock-out but-
ton and trigger are
not pushed at the
same time.
11
Solution
1. Remove battery pack.
2. Check contact and in-
stall the battery pack
again.
Charge the battery pack.
1. Pull the lock-out but-
ton and hold it.
2. Pull the trigger to start
the machine.
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

21272

Tabla de contenido