Installation; Unpack The Machine; Attach The Guard; Assemble The Shaft - GreenWorks STA806 Manual Del Operador

WARNING
Check extension cords before each use. If damaged replace
immediately. Never use the product with a damaged cord
since touching the damaged area could cause electrical
shock resulting in serious injury.
8

INSTALLATION

8.1

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
8.2

ATTACH THE GUARD

WARNING
Do not touch the cut-off blade.
1. Remove the screw from the trimmer head with a Phillips
head screwdriver (not included).
2. Put the guard (1) onto the trimmer head.
2
3. Align the screw hole on the guard with the screw hole on
the trimmer head.
4. Tighten the screw (2).
1
English
8.3

ASSEMBLE THE SHAFT

1. Unlock the cam lever.
2. Insert the lower shaft through the guide groove until you
hear a "click".
3. Adjust the shaft to the most suitable position.
4. Lock the cam lever.
8.4 ATTACH THE AUXILIARY
HANDLE
1. Remove the knob (1) from the handle.
2. Attach the auxiliary handle on the shaft.
3. Set the auxiliary handle in the comfortable position.
4. Tighten the auxiliary handle with the knob .
9

OPERATION

Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1

START THE MACHINE

Use only approved outdoor extension cords.
1. Put the extension cord through the slot on the rear handle
and put it underneath the cord retainer (3).
7
GUIDE HOLE
GUIDE GROOVE
CAM LEVER
1
IMPORTANT
WARNING
NOTE
EN