14 7.4.4 Check Of Number Of Manoeuvres Performed; 14 7.4.5 Manoeuvre Counter Reset; 14 7.5 Connecting Other Devices - Nice Ten TN2010 Instrucciones Y Advertencias Para El Instalador

7.4.4) Check of number of manoeuvres performed
The function "Maintenance notification" enables the user to check the number of manoeuvres performed as a percentage of the set limit. To
check, proceed as follows:
Table 16: Check of number of manoeuvres performed
1. Press and hold [Set] for approx. 3s
2. Release the key [Set] when led L1 starts to flash
3. Press keys [▲] or [▼] to move the flashing led to L7, i.e. the "input led" associated with the
parameter "Maintenance notification"
4. Press and hold [Set] during steps 5, 6 and 7
5. Wait approx. 3s after which the led associated with the current level of the parameter
"Maintenance notification" will light up.
6. Briefly press keys [▲] and [▼]
7. The led corresponding to the selected level flashes a few times. The number of flashes indicates the
percentage of manoeuvres performed (in multiples of 10%) with respect to the set limit.
For example: when the maintenance notification is set on L7 i.e. 10000, 10% corresponds to 1000
manoeuvres; if the indicator led flashes 4 times, this means that 40% of the maximum number of
manoeuvres has been reached (i.e. between 4000 and 4999 manoeuvres).
If 10% has not yet been reached, the led does not flash at all.
8. Release [Set]
7.4.5) Manoeuvre counter reset
After performing system maintenance the manoeuvre counter must be reset.
Proceed as described in table 17
Table 17: Manoeuvre counter reset
1. Press and hold [Set] for approx. 3s
2. Release the key [Set] when led L1 starts to flash
3. Press keys [▲] o [▼]to move the flashing led to L7, i.e. the "input led" associated with the parameter
"Maintenance notification"
4. Press and hold [Set] during steps 5 and 6
5. Wait approx. 3s after which the led associated with the current level of the parameter
"Maintenance notification" will light up.
6. Press and hold keys [▲] and [▼] for at least 5 seconds, then release. The led corresponding to the
selected level shows a series of quick flashes to indicate that the manoeuvre counter has been reset.
7. Release [Set]
7.5) Connecting other devices
If external devices need to be powered, such as a proximity reader
for transponder badges or the lighting of a key-operated selector
switch, power can be supplied as shown in figure 29. The supply
voltage is 24Vcc -30% ÷ +50% with maximum available current of
100mA.
24
29
Example
SET
3s
SET
L1
L7
or
SET
3s
and
X1 = 10%
X2 = 20%
X3 = 30%
X4 = 40%
X5 = 50%
X6 = 60%
X7 = 70%
X8 = 80%
X9 = 90%
X10 = 100%
SET
Example
SET
3s
SET
L1
or L7
SET
3s
and
SET