Typical System; Wiring List - Nice Ten TN2010 Instrucciones Y Advertencias Para El Instalador

2.3) Typical system

Figure 3 shows a typical installation of an automation for up-and-over doors, using TEN.
3
1 TEN
2 Square tube 20x20
3 Support bracket
4 Telescopic arm
5 Photocells

2.4) Wiring list

On the typical system of figure 3 the cables are specified for connection of the various devices; table 6 specifies the relative characteristics
of the cables.
!
The cables used for connecting the various devices must be suitable for the type of installation: For example a cable
type H03VV-F is recommended if located indoors.
Table 6: Wiring list
Connection
A: Electric power line
B: 12V Flashing Light
C: Aerial
D: Photocells
E: Key-operated selector switch
F: Sensitive edge
Note: (*) if the power cable is longer than 30 m, a cable with a larger section is required, (e.g. 3 x 2,5 mm
sary in the vicinity of the automation.
6
6 Photocells on post
7 Sensitive edge
8 12 V Flashing light with incorporated aerial
9 Key-operated selector switch
10 Radio transmitter
Cable type
1 cable (3 x 1.5 mm²)
1 cable (2 x 1 mm²)
1 shielded cable (type RG58)
1 cable (2 x 0.5 mm²)
1 cable (4 x 0.25 mm²)
1 cable (2 x 0.25 mm²)
Maximum admissible length
30 m (*)
20 m
20 m (recommended: Less than 5 m)
20 m
20 m
20 m
2 ) and safety earthing is neces-