Scan From The Adf; Choose Acceptable Media For The Adf; Load Originals In The Adf - HP scanjet 8200 Serie Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

scan from the ADF

3
This section describes how to select originals that are acceptable for the
Automatic Document Feeder (ADF), and how to load and scan originals from the
ADF.

choose acceptable media for the ADF

The ADF works best when the originals meet the following specifications:
standard media of A4, U.S. letter and legal sized paper
nonstandard media ranging in size from 88.9 by 127 mm
(3.5 by 5 inches) to 216 by 356 mm (8.5 by 14 inches)
media weights from 60 to 90 g/m
media that is square-shaped or rectangular and in good condition
media that is free of perforations, or punch holes
media that is free of wet glue, correction fluid, or ink
Note: Avoid putting multipart forms, transparencies, magazine pages, gum-
backed pages, and light-weight paper in the ADF.
Before placing an original in the ADF, check for and remove:
curls or wrinkles
staples, paper clips, and any other attached material
If the originals do not meet these criteria, scan from the scanner glass.

load originals in the ADF

1
Place a stack of similarly-sized originals face up in the document input tray,
with the first page on top. See the icon on the paper input tray.
2
Adjust the paper guides to center the stack.
Use the D
3
originals.
4
Press a scanner button or use the HP Director to begin scanning. Follow the
instructions on the computer screen to finish scanning.
14
load paper and center in the tray
switch on the ADF to select one-sided or two-sided
UPLEX
2
(16 to 24 pounds)

Publicidad

Tabla de contenido
loading

Tabla de contenido