Fitting Instructions - bort medical Select Instrucciones De Uso

EN
– no re-use – this medical aid is intended for treating one patient
– whilst wearing the support, please neither use any creams nor ointments on or
around it as they can destroy the material.

Fitting instructions

Open the brace and loosen the tension straps. Place the BORT select Lumbar spine
brace for mobilisation around the waist and close the front fastener, using the hand
straps as supports. Pay attention to comfortable fitting. In order to additionally
relieve the lumbar spine, tighten the side restraints evenly and simultaneously.
Observe simultaneous pull on both side restraints in order to avoid undesired
rotation on the spine.
During the course of therapy, the restraints can be removed individually, this
decision is taken by the treating physician.
To remove the constraints, please loosen the Velcro fasteners on the sides of the
ventral plates and also the Velcro fastener for the central stabilisation element in the
back region.
Removal
To remove the brace, open the tension straps and the front fastening and take the
brace off.
Material composition
Polyamide (PA), elastodiene/latex (LA)
The sewn in textile label provides the precise material composition.
The product contains latex and can trigger allergic reactions.
Cleaning information
Delicate wash Do not clean chemically Do not bleach
Do not dry in a tumble dryer Do not iron
Do not use fabric conditioner. Stretch back into shape and dry in the fresh air. Close
the Velcro fastening to avoid damage to other laundry items.
08