Cleaning Method; End Of Operation - diversey Taski swingo 755B Manual Del Usuario

Battery capacity - end of operational readiness
The battery level indicator provides information on the available oper-
ating time.
• If the red indicator begins to flash, approx. 2 minutes of
working time are left.
• At machines with automatic brush lowering unit, the brush
motor is switched off and the brush unit is automatically
raised.
At machines with foot pedal, the brush motor is switched
off and the brush unit remains on the ground.
• The red display switches to a continuous light.
• Now you have 10 minutes to drive the machine to the
charging station. Then the machine is automatically
switched off.
• In order to restart, the batteries must be fully charged.

Cleaning method

Direct working method:
Scrubbing and suction in one work step.
Indirect working method:
Applying the cleaning solution, scrubbing and suction in several work
steps.
Notice:
In some circumstances, certain combinations of
flooring/soiling and cleaning products may impair
the guiding of the machine.
- Optionally available wheels can improve the ma-
chine's traction on the floor. Please contact your TAS-
KI customer consultant.
Replenishing cleaning solvent
Warning:
The flooring may be damaged when working with-
out cleaning solution.
Caution:
A rattling sound of the pump indicates that the
fresh water tank is empty.
- The pump must never run dry for an extended period.
• The machine must be switched off.
• Open the tank lid.
• Fill the fresh water tank with water, see page 8.
• Add the cleaning product using the dosing cup.
• Close the tank cover.
Draining dirty water
Recovery tank full:
• If the recovery tank is full, the floater
will be sucked onto the suction filter.
This will be indicated by a change of
the noise by increasing the suction
speed as well as residual water at the
bottom.
• Drain the recovery tank, see page 11.
10

End of operation

• Press the Brush drive ON/OFF but-
ton.
The cleaning solution supply is
stopped.
• Drive on for a few meters so that the brushes keep on ro-
tating for a short time to avoid dripping.
Very important for TASKI contact pads!
Variant: Automatic brush lowering (Option 1255B)
• Press the Brush drive button ON/
OFF.
The display lights up and the brush
unit is stopped and lifted.
• Drive on for a few meters in order to absorb the remaining
drain water.
Variant: Foot pedal
• To lift the tool, push the foot pedal
downwards until it engages.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Lift the suction nozzle.
Allow the suction unit to run on so
that the remaining waste water in the
hose is sucked up.
• Press the Suction unit ON/OFF but-
ton.
The display lights up; the suction en-
gine stops.
• Switch off the machine.
Caution:
The machine must now be emptied and cleaned.
Switch off the machine (main switch) and discon-
nect the battery disconnection socket before begin-
ning with the following steps.